Clearing the Queue

Error - Job could not be added to the queue because it is either already queued or currently executing. There are a few reasons why this error can occur:

1.  Please check that your jobs are not being scheduled too close to each other. If a job is currently running and another job is scheduled to start while the current job is running, you will see this error.  This is normal, as the queue is busy processing the running job. If a job is already in the queue, the queue will not allow it to be queued again until the running job completes, or the Domo Workbench service is restarted.

2. The current job could be in a non-responsive state.  If a job is running for a longer than expected amount of time, opening a case with Domo Support to investigate the issue further would be the correct course of action.

3. While recreating a job with a different name, and deleting the job that is stuck in the queue is one way to reset the queue, I would recommend restarting the workbench service.  Restarting the Domo Workbench service will flush the queue.  Normal workflow of workbench jobs should return after restarting the service.  If restarting the service does not return the workbench to normal operation, please open a case with Domo Support.

I work for Domo.

**Say "Thanks" by clicking the thumbs up in the post that helped you.

**Please mark the post that solves your problem as "Accepted Solution"