Quick Filters on a Drill Path Card

This took me a few minutes to figure out, so hope it may help someone else as well!

 

If you add a quick filter to a drill path card, even though it appears in the analyzer/editor view, it will not appear on the saved card -- UNLESS -- you also add that same quick filter to the TOP LEVEL CARD. 

 

May be a bug, may be by design... I'm asking Domo support to check into it either way. 

Tagged:

Comments

  • THANK YOU for posting this. I had the same issue today - a user added a couple of quick filters within a card's drill path but we could only see those quick filters once we enabled them on the top level.

     

    Thank you for contacting Domo Support about this. 

  • Domo support confirmed this is a bug:

     

    "Our development team has found a fix for the reported behavior. This is currently going through initial testing to ensure the proposed changes will fix this behavior."

     

    Case #05657225

  • Is this fixed? I am getting an error on this

This discussion has been closed.