Force Value Scale (Line) and Value Scale (Bar) to be equal

j-armstrong3
j-armstrong3 Member
in Archive

I am looking to create a card with 2 lines and one bar that all use the same scale.  In my case it is Indirect Wages by day (Bar), Indirect Wages MTD (Line) and Budgeted Indirect Wages (Line).  I am running into an issue though were depeding on my date range the Scale gets off and it looks like my daily spend is greater than my MTD spend.  Can i force the two scales to be the same?

Comments

  • Godiepi
    Godiepi Coach

    Under Chart Properties > General , check the box that reads "Sync Value Scales"

    Domo Arigato!

    **Say 'Thanks' by clicking the thumbs up in the post that helped you.
    **Please mark the post that solves your problem as 'Accepted Solution'
  • Godzilla
    Godzilla Contributor

    if you don't want the scale to change, you can set a min and max for the scales under the properties as well. the downside of doing this is if any of the values go above or below the specified range, you'll have to manually adjust. 

    Domo Arigato!

    **Say 'Thanks' by clicking the thumbs up in the post that helped you.
    **Please mark the post that solves your problem as 'Accepted Solution'
This discussion has been closed.

Categories