Dataflow wont run!

Options
nicolac
nicolac Member
in Magic ETL

Hi I have my dataflow in Domo and it ran fine. I then added a bit to it to bring in more information and it saves and the preview runs fine. I expanded the preview to check the max number of lines. But....when I now go to save and run it, it just tells me DataFlow was saved, but could not be run. Any thoughts on what I can check that is causing this block?

In the dataset overview, I don't have the history option between the lineage and pdp headings.

Nicola.

Answers

  • GrantSmith
    GrantSmith Coach

    Are all your tiles highlighted or are there some that are greyed out (I'd look at these if you have any)?

    **Was this post helpful? Click Agree or Like below**
    **Did this solve your problem? Accept it as a solution!**
  • jaeW_at_Onyx
    jaeW_at_Onyx Coach

    usually if the dataflow isn't bugged (as @GrantSmith suggested), if the dataflow won't run it's b/c it's already running.

    Jae Wilson
    Check out my 🎥 Domo Training YouTube Channel 👨‍💻

    **Say "Thanks" by clicking the ❤️ in the post that helped you.
    **Please mark the post that solves your problem by clicking on "Accept as Solution"
  • nicolac
    nicolac Member

    Tiles etc all looked fine. Not entirely sure how but its working fine now.

  • Atieh
    Atieh Member

    Looking to the get answer for the same error. all the tiles looks good and there is no gray tile. any reason why I am getting this error?

    image.png
  • MichelleH
    MichelleH Coach

    @Atieh When I've received that error before, it's usually because the dataflow is already running. I would check the dataflow history to see if that's the case.

  • Atieh
    Atieh Member

    @MichelleH I checked to see if it was already running, and it wasn’t. I left it for a day and came back to it, but I’m still getting the same error.

  • MichelleH
    MichelleH Coach

    @Atieh Do you get an error message if you try to manually run from the dataflow history screen instead of "Save and Run"?

  • Atieh
    Atieh Member

    @MichelleH This is a new ETL and that hasn’t been run before. So I have to do the Manual run anyways.

  • MichelleH
    MichelleH Coach

    @Atieh The message in your screenshot says it was saved, so you don't have to run it from the ETL editor screen. If you attempt a manual run from the dataflow history it should provide more details on why the run fails.

  • Atieh
    Atieh Member

    @MichelleH

    The problem is I am not seeing the run option on the ETL

    image.png
  • MichelleH
    MichelleH Coach

    @Atieh These looks like the options for the output dataset, not the dataflow. If you click "View DataFlow" it you should see an option to re-run it.

Categories