Output/Preview Window

fieryknight
fieryknight Member
in Workbench

I accidentally closed my output/preview window in my workbench, how do i get it back? 

 

I was trying to find an option but didn't see any.

 

Thanks.

Best Answer

  • fieryknight
    fieryknight Member
    Answer ✓

    some jobs ran fine as they are running daily. there was one that failed.

     

    I had to re-install my workbench and reconfigure it to make it work. Its working now...

Answers

  • NewsomSolutions
    NewsomSolutions Domo Employee

    You should have a small tab at the bottom left of your screen that has "Preview" and another that says "Output".  If you hit the X in the preview pane and it shows up and is just blank, hit the "Preview" eye at the top  on the menu bar and that should work.

  • fieryknight
    fieryknight Member

    there is no preview/output window showing up. I have attached a screenshot here.

  • NewsomSolutions
    NewsomSolutions Domo Employee

    You don't have Preview at the top showing because you aren't focused on a job...so if you expand the jobs and highlight one you'd get that option showing back at the top...if not close and reopen workbench.  

     

    I'd try to close/reopen workbench if that doesn't work.

     

    If all else fails, think about what version of workbench you're on.  I can't remember problems with older versions, but I always see Preview/Output in mine..so it may be something up with the version you are on....but that is just a guess.

  • fieryknight
    fieryknight Member

    it was there this morning but i accidentally clicked on close on that tab :(

     

    I tried to close and re-open workbench, didn't work.

     

    preview button works when i focus on a job but it doesn't show the preview or the ouput even when i click on preview or run.

     

    my workbench version is 4.62.6715.32090

  • NewsomSolutions
    NewsomSolutions Domo Employee

    And the job has no errors and ran fine?  Did you look over the logs?

  • fieryknight
    fieryknight Member
    Answer ✓

    some jobs ran fine as they are running daily. there was one that failed.

     

    I had to re-install my workbench and reconfigure it to make it work. Its working now...

This discussion has been closed.

Categories