Line in Line bar chart and Multi-line chart does not filter with x-axis value

RZ
RZ Member

I have a line+bar chart which has 3 series of data, with one line and two bars. What I observed is:

Clicking the dot on the line only filters with the series value, ignoring the x-axis value.

Clicking the bar does filter with both series value and x-axis value normally.

If I change the chart type to Multi-line, then any line filters with only the series value as well, ignoring the x-axis value.

If I change the chart type to stacked-bar chart, then any bar filters with both series value and x-axis value successfully.

My question is, why the line in the above chart types can not filter with both series value and x-axis value at the same time, while the bar can?

Is there any way to make it work?

Answers

  • The way Domo works with different chart types, often depends upon the underlying chart interaction settings and how Domo is designed to handle filtering on the chart types. Currently, I don't think Domo has the ability for line clicks to filter by both series and x-axis values in line bar charts or multi line charts. You could try to work around the limitation by setting up custom drill paths and variables.

    ** Was this post helpful? Click Agree or Like below. **
    ** Did this solve your problem? Accept it as a solution! **