Table Cards - clicking and drilling on selected columns/rows gives wrong drill filter


Any time I use a Table Card in a drill layer (and even top level i spose) - the user can click on any of the data in the rows.

For example, I may have a column that does a count

  • Count of service requests. on a table chart that lists all properties and their respective service request counts

When the user clicks on that count - it will filter to rows looking for a "Service Request = 12", which will obviously never be found because it is a count of service requests.

**Can w have a way to setup each column with a "Do Not make this selectable" or something settings?



  • GrantSmith

    Currently this isn't possible however I'd recommend adding this to the idea exchange to allow more flexibility with drill paths

    **Was this post helpful? Click Agree or Like below**
    **Did this solve your problem? Accept it as a solution!**