Workbench Restarts when "Source File Doesn't Exist"

trafalger
trafalger Contributor
in Workbench

Hello!

I'm running into an issue where I have workbench on a server with ... "issues." Sometimes I get "Source file does not exist" (the file absolutely exists) and then that workbench job doesn't run again until the job is manually ran. Any way to get this job to restart even if it thinks the source file doesn't exist? Am I missing some setting somewhere?

Tagged:

Best Answer

  • GrantSmith
    GrantSmith Coach
    Answer ✓

    Have you updated to the latest version of workbench and rebooted the server or in the famous words of the IT Crowd: “Have you tried turning it off and on again?”

    **Was this post helpful? Click Agree or Like below**
    **Did this solve your problem? Accept it as a solution!**

Answers

  • GrantSmith
    GrantSmith Coach
    Answer ✓

    Have you updated to the latest version of workbench and rebooted the server or in the famous words of the IT Crowd: “Have you tried turning it off and on again?”

    **Was this post helpful? Click Agree or Like below**
    **Did this solve your problem? Accept it as a solution!**
  • trafalger
    trafalger Contributor
    edited August 2022

    I will try updating, I'm not sure the last time that it's been updated.

Categories