How can I change the Append to Replace for an already created card?

I already have a set of created cards that I have been using for a while. Where can I go and change Append to Replace in those cards?

I am unable to do that through Datacenter>Datasets>Overview I am unable to find any option here. Is there any other way I can get the option other than recreating the cards all over again?

Comments

  • I would recommend creating the new dataset with the replace option and then use the "Switch cards to a different Dataset" option (see right side of image below) to shift your existing cards to use the new dataset.

     

    Screen Shot 2015-10-30 at 9.07.10 AM.png

     

    If your column names are the same in both datasets, it's a very straightforward process and takes a matter of seconds.

  • kshah008
    kshah008 Contributor

    @rhowe21, did the above reply help address your question?

This discussion has been closed.